*Pages 1--2 from  Microsoft Word - 43844.doc*
 Federal  Communications  Commission 
 Before  the  Federal  Communications  Commission 
 Washington,  D.  C.  20554 


 In  the  Matter  of 
 Amendment  of  Part  15  regarding  new  requirements  and  measurement  guidelines  for  Access  Broadband 
 over  Power  Line  Systems 
 Carrier  Current  Systems,  including  Broadband  over  Power  Line  Systems 


 )  ) 
 )  ) 
 )  ) 
 )  ) 
 ) 


 ET  Docket  No.  04-  37 
 ET  Docket  No.  03-  104 


 ERRATUM 
 Released:  November  12,  2004 
 By  the  Chief,  Office  of  Engineering  and  Technology: 


 1.  On  October  28,  2004,  the  Commission  released  a  Report  and  Order,  FCC  04-  245,  in  the  above  captioned  proceeding.  This  erratum  makes  the  following  corrections  to  the  Report  and  Order. 
 2.  Paragraph  3  of  Appendix  B  of  the  Report  and  Order  should  read: 
 3.  Section  15.  15  is  amended  by  revising  paragraph  (b),  to  read  as  follows: 
 Section  15.15  General  Technical  Requirements 
 *  *  *  *  *  (b)  Except  as  follows,  an  intentional  or  unintentional  radiator  must  be  constructed  such  that  the 
 adjustments  of  any  control  that  is  readily  accessible  by  or  intended  to  be  accessible  to  the  user  will  not  cause  operation  of  the  device  in  violation  of  the  regulations.  Access  BPL  equipment 
 shall  comply  with  the  applicable  standards  at  the  control  adjustment  that  is  employed.  The  measurement  report  used  in  support  of  an  application  for  Certification  and  the  user  instructions 
 for  Access  BPL  equipment  shall  clearly  specify  the  user-  or  installer-  control  settings  that  are  required  for  conformance  with  these  regulations. 


 *  *  *  *  * 
 3.  Paragraph  4  of  Appendix  B  of  the  Report  and  Order  should  read: 
 4.  Section  15.31  is  amended  by  revising  paragraph  (f)(  5),  to  read  as  follows: 
 Section  15.31  Measurement  standards. 


 *  *  *  *  * 
 (f)  *  *  * 
1
 Federal  Communications  Commission 
 2 
 *  *  *  *  * 
 (5)  Measurements  shall  be  performed  at  a  sufficient  number  of  radials  around  the  equipment  under  test  to  determine  the  radial  at  which  the  field  strength  values  of  the  radiated 
 emissions  are  maximized.  The  maximum  field  strength  at  the  frequency  being  measured  shall  be  reported  in  the  equipment  authorization  report.  This  paragraph  shall  not  apply  to  Access  BPL 
 equipment  on  overhead  medium  voltage  lines.  In  lieu  thereof,  the  measurement  guidelines  established  by  the  Commission  for  Access  BPL  shall  be  followed. 


 *  *  *  *  * 
 4.  Paragraph  5  of  Appendix  B  of  the  Report  and  Order  should  read: 
 5.  Section  15.  37  is  amended  by  adding  paragraph  (m)  to  read  as  follows: 
 Section  15.  37  Transition  provisions  for  compliance  with  the  rules. 
 *  *  *  *  *  (m)  All  Access  BPL  devices  that  are  manufactured,  imported,  marketed  or  installed  on  or 
 after  [insert  date  18  months  from  date  of  publication  in  the  Federal  Register]  shall  comply  with  the  requirements  specified  in  subpart  G  of  this  part,  including  certification  of  the  equipment. 


 5.  This  action  is  taken  pursuant  to  authority  contained  in  Section  0.241  of  the  Commission’s  rules  on  delegated  authority,  47  C.  F.  R  §  0.241(  a),  and  these  corrections  shall  be  included  in  the  Report 
 and  Order,  prior  to  its  publication  in  the  Federal  Register  and  FCC  Record. 


 FEDERAL  COMMUNICATIONS  COMMISSION 


 Edmond  J.  Thomas  Chief 
 Office  of  Engineering  and  Technology 
2